83 VMX 540 sold thanks
-
MELROSEMAFIA
- Posts: 49
- Joined: Sun Jan 02, 2011 11:35 am
83 VMX 540 sold thanks
.
Last edited by MELROSEMAFIA on Sun Oct 02, 2011 5:56 pm, edited 2 times in total.
-
Bob Vehring
- Posts: 659
- Joined: Tue Feb 24, 2009 12:42 am
- Location: Milw. Wi
Re: 83 VMX 540 MAG SIDE TEMP ???
What are you using to gauge cyl temp, EGT or head temp?
-
MELROSEMAFIA
- Posts: 49
- Joined: Sun Jan 02, 2011 11:35 am
Re: 83 VMX 540 MAG SIDE TEMP ???
.
Last edited by MELROSEMAFIA on Tue Sep 27, 2011 12:31 pm, edited 1 time in total.
-
Bob Vehring
- Posts: 659
- Joined: Tue Feb 24, 2009 12:42 am
- Location: Milw. Wi
Re: 83 VMX 540 MAG SIDE TEMP ???
Well then, I assume you are either doing this at an idle, or you can run very fast.
At idle it could or probubly is idling on one cyl more then the other. Could be a idle screw setting, not enough slack in one side of the cable, ajustment of the low speed screw, plugged low jet, bad plug or wire on that side. The next question would be, do the temps even out as the sled is run at speed?
At idle it could or probubly is idling on one cyl more then the other. Could be a idle screw setting, not enough slack in one side of the cable, ajustment of the low speed screw, plugged low jet, bad plug or wire on that side. The next question would be, do the temps even out as the sled is run at speed?