Speedo drive

modsingle · Post by **modsingle** » Fri Apr 23, 2010 9:07 am

End of the season this year, my speedo stopped working. I found the square hole in the drive axle to be rounded out. The small square piece is bad also but I can get them out of Dennis Kirk. Where do I get the piece that goes into the drive axle? How do I install? Drill the old one out? Anyone else do this job?

sxr1000 · Post by **sxr1000** » Fri Apr 23, 2010 1:37 pm

I have a new piece that goes into the drive axle,they just press in,use a slide hammer to get the old one out.