Lights that dim on braking ?

[tyler440]

we (me and chuck) are interested in building on of these... i assume whe could use some type of bread board and solder everything together?.... whats the chances this would work on other sleds?

[Vmax540]

"If anyone is interested in building one of these, let me know. I can run it through the circuit simulator and verify it works before puiblishing a schematic and parts list."


Yes, and I would be glad to provide you will all the parts just, send a list and consider it done !

[Joe]

There is a high probablility that it would work on all snowmobiles that use a shunt type regulator.

I probably have all the parts (except the regulator IC) needed to build a prototype .

My electrical CAD system is in the garage. I normally don't leave the heat on out there. The heat warms up the air, but the concrete stays cold a LONG time.

This stinking cough keeps knocking me down. I have a lot of catching up to do after after being incapacitated for 8 days.

Right now, the health, education and career obligations will need to get most of my attention.

If it is like my other inventions, I wont be able to focus on anything else until I pass it off to someone else to develop further.

[tyler440]

well when you get a chance to draw up a schematic, do so and send it over:)... send it to my email address tylerochs@hotmail.com.... here at the vintagevmax stable are of our sleds are running just fine, so now we are looking into things that have been annoying us!