help

coletrain9896 · Post by **coletrain9896** » Wed Jan 23, 2008 6:08 am

ok i got the carbs all clean and i put them back on and now it wont start at all it does not even seam like its trying to fire but the plugs have a good spark when i pulled them out
any help would be great

jefflanthier · Post by **jefflanthier** » Wed Jan 23, 2008 9:47 am

Is your engine getting fuel?????/

Post by **tyler440** » Wed Jan 23, 2008 10:54 am

agreed spark+fuel+compression=FIRE!.... when you pull the plugs are they wet?... i have had slides "hang up" due to improper reassembly and therefore you trying to start it at wide open throttle.... if you unscrew the carb "cap" and it blows out like a jack in the box then you know that was the case... put it back together and make sure you get your needle down where it belongs... let use know what you find out....

coletrain9896 · Post by **coletrain9896** » Thu Jan 31, 2008 11:27 pm

ok i just got it going and ran it around the yard it was doing ok but there was a bog in the mid range like 4600 rpm and then if you held it there it would clear it self out and take off like a bat out of hek but then after awihile of that it just lost power and did not want to go at all the clutch was engaging at 3500 but now it will rev up to 4000 -4200 and then just barely moves any ideas

SRXfromHELL · Post by **SRXfromHELL** » Sat Feb 02, 2008 1:20 am

1 check plugs might have one fouled 2 might have dropped a needle pull the caps and make sure the clip didn't fall out happened to me once