Page 1 of 1
motor swap in vmax?
Posted: Fri Dec 28, 2007 10:57 pm
by valin
Has anyone here done a motor swap on a Vmax 540? I am considering building a bit of a project sled, but am concerned about being able to fit a case reed twin motor in that chassis. I suppose an SRX700 motor would not fit in that chassis either. I'm sure pipes would certainly be an issue. I do not have my '91 vmax yet, so I have no measurements to go by. Please let me know of your opinions and experience with this.
Posted: Sun Dec 30, 2007 2:37 am
by jipcee
We have a 85 Phazer with a 91 Polaris 650 Triple, it was a real tight fit and frame mods hade to be made.
This summer we are going to stuff a 04 Viper triple in the Phazer and it looks like it will fit.
So, I think you should be able to fit srx triple in.
Getting the motor in and mounted and aligned will probably be the easy part compared to the cutting welding and routing of the pipes.
I think a SXR 700 would be alot easier with the single pipe and they are not that much slower than a SRX.
You are going to need a few things:
Patience
Money
Machine shop
Knowledge
and More Patience!
Good luck! Please take lots of Pictures and post'em
Posted: Sun Dec 30, 2007 12:22 pm
by opsled
Never say "NEVER". Go ALLLLLL the way and build yourself an "ULTIMAX"
opsled
Posted: Sun Dec 30, 2007 2:51 pm
by Undertaker#13
Posted: Sun Dec 30, 2007 4:31 pm
by jipcee
Yeah, the Polaris engine is a real P.O.S. thats why we are putting in the Viper engine.
Posted: Sun Dec 30, 2007 10:26 pm
by valin
I will not just be putting an SRX motor in. It will be a well ported 780 big bored SRX with 38mm carbs from a MachZ that are bored to 40.5's, and I will run Jaws lakerace pipes. The motor should be in the 180 hp range, on low compression and pump fuel. It should be a fun project.
Posted: Mon Dec 31, 2007 12:16 am
by vmax-540
Polaris .... Don't they make chain saws or somthing like that !!I I thought they went out of business back in the 60's OH well it sure looks pretty with those red heads on there !!!
Posted: Tue Dec 01, 2009 12:24 am
by vintagemuscle
thats what i'm about to start.... 81 srx/2000 srx 700. just collecting the rest of the parts then it's a go
i'm hopin the pipes aren't too much of a pain[/img]
Posted: Tue Dec 01, 2009 3:04 am
by Bob Vehring
How do you get 38 mm carbs bored to 40.5 to idle?
Posted: Tue Dec 01, 2009 6:07 pm
by onebun
opsled thats awsome man!!!! would love to see more pics diferent angles and such a breif description of the machine would be cool to onebun
polaris engine in a Yamaha 
