Page 1 of 1
ANYBODY HERE, INCUDEING CHUCK. 3:16
Posted: Mon Jan 07, 2013 7:58 pm
by YAMMIEGOD 3:16
I NEED A GOOD WORKING WATER TEMP GAUGE FOR A 83-87 VMAX. DON,T CARE ABOUT FACE (numbers or scale) HAVE TWO HERE AND THEIR BOTH JUNK. LET ME KNOW. 3:16 (yammie tony)
Re: ANYBODY HERE, INCUDEING CHUCK. 3:16
Posted: Mon Jan 07, 2013 8:16 pm
by opsled
Did you test them in hot water Tony? Cuz if you are waiting for one to move while on the sled you might wait a long time. I don't know if it's because of the placement of the probe in that bypass line or what but I have never had one move much at all on the sled.
opsled
PS, I probably have a good one if needed (would have to test to be sure) but can't garauntee you will see it work on the machine.
Re: ANYBODY HERE, INCUDEING CHUCK. 3:16
Posted: Mon Jan 07, 2013 8:39 pm
by YAMMIEGOD 3:16
PHIL I NOTICE THAT ON MY 83, BUT THIS GAUGE BROKE WHERE NUT SCREWS INTO HOUSING. OTHER ONE I HAD WAS FROM A 87 SCALE COLOR SCREEN, THAT WAS BROKE TOO. USED HOT WATER FROM MICR WAVE. lol. if ya can spare a good one, let me know. hey i sent that vmax 4 stuff back to ya. 3:16 (yammie tony)
Re: ANYBODY HERE, INCUDEING CHUCK. 3:16
Posted: Mon Jan 07, 2013 8:48 pm
by opsled
OK Tony, I'll check out what I have and let ya know.
opsled
Re: ANYBODY HERE, INCUDEING CHUCK. 3:16
Posted: Mon Jan 07, 2013 8:57 pm
by opsled
That was easy. Didn't even have to go to the barn. Got a good one will send it in the am. Do you need the plastic it screw into? hoses?
opsled
Re: ANYBODY HERE, INCUDEING CHUCK. 3:16
Posted: Mon Jan 07, 2013 10:15 pm
by YAMMIEGOD 3:16
ANYTHING YOU HAVE. LET ME KNOW WHAT I OWE YA. 3:16 (yammie tony)
Re: ANYBODY HERE, INCUDEING CHUCK. 3:16
Posted: Sat Feb 02, 2013 6:20 pm
by Bob Vehring
For whatever its worth, I tried 2 oem gauge then put in a known good Autometer gague all read the same, damn near nothing untill it got really hot. I had the engine out and took apart the lines to this by pass hose. IMO theres nothing there that makes any water travel up that line, I doubt if it gets any flow.
When I get mine back together, which is getting closer, I'm going with a one of the inline sensors in the bigger hose