center to center adjustment
Posted: Mon Dec 26, 2011 10:03 pm
How do you adjust clutch center to center? Do you have to slide the engine? Does it have adjustemnt holes?
Thanks
Thanks
Lightly loosen the four mounting bolts. There is enough wiggle room. Offset is changed by moving (exchanging) the washers/shims from the backside or outside of the secondary clutch.
http://www.vintagevmax.com/1986_service.htm
Drive- Engagement rpm/ Shift rpm 4000 +/- 200 rpm/ 8200 +/-200rpm
Belt Length/ Width/ Wear Limit/ IBM Number 1175mm/ 31.6mm/ 26mm/ 8M6
Sheave Center to Center/ Offset 305 +/-1.0mm/ 11 +/-0.5mm
Primary Spring Color/ Length/ Rate/ Preload Pink/ 75.5mm/ 2.31Kg-mm/ 32.8 Kg