Page 1 of 1
Pimp Drive gear oil/water seal
Posted: Fri Feb 03, 2006 5:34 pm
by Guest
I'm looking for an oil/water seal for the pump drive gear on my 83 Vmax. Everywhere I look it is not available or backordered. Can anyone help or give me direction to where I can get one.
http://www.highlandsyamaha.com/parts.aspx Part #3[/img]
Posted: Sat Feb 04, 2006 1:22 am
by Donnie
Which gasket are you trying to find? I went to the link you gave and it started me out in the brakes category. I can use the link if you telling me which category to look under to see which #3 part you were looking at. I have a few gaskets left over from an engine build. I may have the one you need.
Donnie
Posted: Sat Feb 04, 2006 1:24 am
by Vmax540
From Yamaha's own site take a look at the 87 Vmax schematic the seal is different 93103-25146-00 OIL SEAL, SW-TYPE I ordered and recieved one this summer. Maybe you can switch over to the newer style ?
Posted: Sun Feb 05, 2006 3:44 pm
by Guest
Donnie wrote:Which gasket are you trying to find? I went to the link you gave and it started me out in the brakes category. I can use the link if you telling me which category to look under to see which #3 part you were looking at. I have a few gaskets left over from an engine build. I may have the one you need.
Donnie
It's part #3 in the Pump drive gear section
Posted: Sun Feb 05, 2006 7:12 pm
by Donnie
I was looking at the picture you were talking about but I think #3 is pointing to a bearing. Are you looking for #27 ???
Donnie
Posted: Mon Feb 06, 2006 11:47 am
by Guest
Donnie wrote:I was looking at the picture you were talking about but I think #3 is pointing to a bearing. Are you looking for #27 ???
Donnie
#2 is a bearing. #3 is a seal. #27 is a gasket.
I need #3. Look on the chart that references #3. It is an oil seal.
Thanks
Posted: Mon Feb 06, 2006 10:20 pm
by Donnie
OK, I see. I thought there was a bearing on both sides. I don't have that seal. Sorry.
Donnie