Page 1 of 1
piston compatibility
Posted: Fri Feb 25, 2011 9:27 pm
by smoknbs
Has any one looked at the 600 vmax pistons as to pin location to top , ring pin location to ports and skirts as to boring out a 540 , the reason for is I have a pair of cyl that are 1.5 mm over but dont ' true ' a lot of shiny lines vertically like its not bored round , the stock 600 piston is .3 mm bigger than the 1.5mm oversize might be the cheapest way to save them other than new sleeves steve
Re: piston compatibility
Posted: Sat Feb 26, 2011 1:53 am
by Vmax540
Steve, altough I do not know 600 pistons it would be interesting to know. Maybe, Wiseco could have an answer as to if any other piston could be fitted.
Re: piston compatibility
Posted: Sat Feb 26, 2011 2:02 am
by Vmax540
Check out Bobs big bore (Voodoo Vmax) in the project section. Do some searches others have done 600's.
viewtopic.php?f=7&t=1167
http://i1181.photobucket.com/albums/x43 ... ure022.jpg
