VintageVmax.com

we (me and chuck) are interested in building on of these... i assume whe could use some type of bread board and solder everything together?.... whats the chances this would work on other sleds?

"If anyone is interested in building one of these, let me know. I can run it through the circuit simulator and verify it works before puiblishing a schematic and parts list."


Yes, and I would be glad to provide you will all the parts just, send a list and consider it done !

There is a high probablility that it would work on all snowmobiles that use a shunt type regulator.

I probably have all the parts (except the regulator IC) needed to build a prototype .

My electrical CAD system is in the garage. I normally don't leave the heat on out there. The heat warms up the air, but the concrete stays cold a LONG time.

This stinking cough keeps knocking me down. I have a lot of catching up to do after after being incapacitated for 8 days.

Right now, the health, education and career obligations will need to get most of my attention.

If it is like my other inventions, I wont be able to focus on anything else until I pass it off to someone else to develop further.

well when you get a chance to draw up a schematic, do so and send it over:)... send it to my email address tylerochs@hotmail.com.... here at the vintagevmax stable are of our sleds are running just fine, so now we are looking into things that have been annoying us!