hi
Please help
i was getting my vmax ready for the season and it wouldn't start so i siphoned out the old gas changed plugs and i poured a little gas down each cylinder and pulled it over a few times,so then i added new gas installed plugs, pulled it started on first pull then as soon as gas burned out of the cylinders it died and wouldn't restart without pulling the plugs and pouring a little gas down each cylinder , it started right up then died. ...any help would be greatly appreciated i admittedly don't know much about snowmobiles please help
thanks
please help 86 vmax wont stay running
-
- Posts: 659
- Joined: Tue Feb 24, 2009 12:42 am
- Location: Milw. Wi
Re: please help 86 vmax wont stay running
Make sure the fuel shut offs are turned back on
Re: please help 86 vmax wont stay running
check your fuel shut off if thats not it youur fuel pump took a dump .
Last edited by agfirecat on Sat Dec 10, 2011 11:15 am, edited 1 time in total.
Re: please help 86 vmax wont stay running
hi
could you tell me where the fuel shut offs are located ?
thank you
could you tell me where the fuel shut offs are located ?
thank you
Re: please help 86 vmax wont stay running
1983-85 Behind the radiator under the hoodminocqa wrote:hi
could you tell me where the fuel shut offs are located ?
thank you
86-91 Lever on the dash (fuel shut off "ON Position" means fuel is shut off) lesson I learned years ago.......
http://www.vintagevmax.com/serial_numbers.htm
https://www.youtube.com/watch?v=PFb6NU1giRA
"I prefer dangerous freedom over peaceful slavery." Thomas Jefferson
"I prefer dangerous freedom over peaceful slavery." Thomas Jefferson
Re: please help 86 vmax wont stay running
thank you so much for your help it runs 

-
- Posts: 445
- Joined: Fri Nov 21, 2008 12:38 pm
Re: please help 86 vmax wont stay running
Some idiot took the shut off vvalves off my vmax these shoemaker hacker mechanics kill me.
Re: please help 86 vmax wont stay running
if the fuel is on, then your carbs are dirty. take them off and clean them
My airbox is held on by one screw, not because Im lazy but because it is less weight!
Any questions or comments about this site itself can be directed to me at tylerochs@hotmail.com
Any questions or comments about this site itself can be directed to me at tylerochs@hotmail.com