VintageVmax.com

Thanks for the info, Will it only turn so far or these a degree I should be going for ?

Thanks
Steve

Hopefully someone can refresh my tired brain on how to preload and which way to turn the clutch to ge the best results..

Thanks in Advance All,

Steve

Awesome, Thanks for the post,

Looking for the chain tension, Thanks Steve

Hey Guys, Well summer is over Whoo..Hooo..

Anyone have the proper procedure for adjusting the chain tension on an 83,

Thanks Steve

Guys, Anyone know any aftermarkets that are producing windsheilds for our V's ?

Thansk Steve

Got 2 o8 Nytros and I would rather get on the Ol "V"
Thanks for the help guys she runs A1

Been away for a few days guys, Will hopefully have it purring tonight.
Thanks again for all the tips !!

S-

turn the carb upside down.... measure the distance from the carb casting (without the gasket) to the part of the float closest to the venturi.... (hope this makes sense, im trying not to refer to "top" and "bottom").... with the carb upside down the float should rest awfully clo...

It apperas both needles arent sealing as they should.I have a few new ones coming, As far as setting the float is there a procedure to follow, I seem to be short about 3 hands in trying to set them Should it be 18 mm from where they hang at the full down position to where there meet at the needle en...

sxr1000 wrote:Replace your needle and seats,it is filling up with fuel and overflowing out the vents.

Thanks for you help, I will give it a shot.
Is the little tang on the bottom of the needle and seat a crutial measurement as far as its angle that it hangs at ?

Steve

Well Guys My VMax sauga continues, Getting close I think though. Had it out for a few short runs ran great, After a wide Open throttle it would flood out and drop the left Cyl. Pull plpes drain, New plugs good again until I would open it up, Took apart the left card and adusted the little brass tang...

Marc Machine wrote:Tyler440 is right. Standard spring position "C" in the number 2 hole.

Do you need to preload these when putting them back together ?

Thanks Guys,

Steve

Great Thanks for the tips.

can anyone confirn where the bleeder screw for the cooling system is ?
I think its in the head just want to be sure,

Thanks Steve