Wiseco ring gap.

[whiskeydent1]

Hi. Rebuilding a 86 540. Standard bore, Steel sleeved with Wiseco piston's & CD ring's. I gapped the ring's at 0.012. Am I good to go or should I open them up to 0.014? Thank's.

[YAMMIEGOD 3:16]

DO YOU HAVE SERVICE MANUAL. I WOULD GO WITH STOCK SPEC IF THIS IS STANDARD BORE.3:16 (YAMMIE TONY)

[Vmax540]

http://www.vintagevmax.com/1986_service.htm

[whiskeydent1]

Thanks. I opened them up to .014 as per service manual. I was not sure as Wiseco info called for .004 per 1" bore. Breakin happen's Sunday afternoon I hope. Waiting for snow.

[Vmax540]

Wiesco = let it warm up good Before to much flipper.

[whiskeydent1]

I hear you on that. Don't want to smoke a new top end. Snowed but not enough. Can't wait!!!!

[YAMMIEGOD 3:16]

5 minute idle time works wonders. 3:16

[whiskeydent1]

Started last weekend for break-in. Starving for fuel. Forgot to replace fuel line's in tank from fitting's to filter. Replaced & Ran it like I stole it for 3 mile's. Run's great. No leak's. Alot of snow coming Saturday night. Time to RIDE!